Azuga Plus Windshield Mount

At a glance

What it is

The shop describes this as an adjustable windshield mount for the SafetyCam Plus that gives stable positioning and a suitable camera angle. It was in stock at $10 on 2026-10-21. The shop lists no weight rating, no adhesive type and no size, so we cannot say more about the part itself.

When you need a replacement

• The first mount was fitted to the wrong spot and the plate has to come off.
• The camera is moving to a different vehicle and the old plate stays on the old glass.
• The plate lifted, was damaged or was lost.
• A windshield was replaced and the plate went with it.

Some customer reviews of Azuga hardware mention a dash cam falling off its mount. We cannot tell which camera or mount those reviews mean, so we treat them as a reminder to do the glass prep properly, not as a verdict on this part.

The steps Azuga documents

1. Choose a spot near the rear-view mirror on the driver side that blocks neither the view nor either lens.
2. Clean the glass with an alcohol wipe.
3. Press the plate on for 30 seconds.
4. Wait at least 15 minutes before the camera goes on.
5. Slide the camera onto the plate until it clicks.
6. Tighten the hex screw, which is a Plus-specific step in Azuga's guide.
7. Fit the SD and SIM cover and remove the lens film.

Aim before you stick

Azuga says not to mount until both angles are set using live streaming. The road view should show the whole road, aimed at the road and not the sky, parallel to the ground. The driver view should show at least half the driver's body, with head and shoulders. If the road view and driver view conflict, road view has priority. A plate that is stuck on crooked cannot be fixed without replacing it, which is why this is the one time to be slow.

Glass and weather

Fit the plate when the vehicle is not in a cold garage and the glass is clean and dry. Azuga says to wait 15 minutes, and we would add more time in cold weather. That is general practice, not an Azuga rule. Check local rules about objects on the windshield for your area before choosing the spot.

Where to go next

Questions we get

Can the Pro use this mount?

The shop sells a separate Pro mount at the same price. Azuga does not say the two are interchangeable, so use the one listed for your model.

Can I move the camera to another car with the same plate?

The plate sticks to the glass, so the plate stays. The camera slides off and onto a plate on the next vehicle. You would need a plate for each vehicle.

Does it need tools?

Azuga's Plus guide has a hex screw to tighten. The shop does not say if a tool ships with the mount.

Sources: Azuga shop product page, checked 2026-10-21, Azuga OEM and hardwire install guide, Azuga dash cam page, Azuga SafetyCam status article. AZUGA is a trademark of its owner. API Signal is an independent installer and is not Azuga.