Azuga Pro Windshield Mount

At a glance

What it is

The shop describes this as an adjustable windshield mount for the SafetyCam Pro, giving stable positioning and a suitable camera angle. It was in stock at $10 on 2026-10-21. No adhesive type, load rating or dimensions are listed, so we make no claims about those.

Why the angle matters so much

Azuga warns that misaligned lenses stop events from triggering. That is the real cost of a bad mount. A camera that looks fine on the glass but points at the sky or misses the driver's shoulders will stay quiet when it should flag something. So the mount is not a cosmetic detail. It decides whether the camera does its job. Azuga says to set both angles with live streaming before you mount, and to give the road view priority when the two conflict.

Fleet handling: spare plates

• Keep a few spares. At $10 a plate, one spare per few vehicles costs little compared with a wasted visit.
• Label what you carry. Keep Plus and Pro mounts apart, because the shop lists separate parts for each.
• Record the plate position. A photo of where the plate sits makes a swap faster and keeps the angle consistent.
• One plate per vehicle. When a camera moves between trucks, the plate stays on the glass.

The mount steps Azuga documents

1. Choose a spot near the rear-view mirror on the driver side that blocks neither the view nor either lens.
2. Clean the glass with an alcohol wipe.
3. Press the plate on for 30 seconds, then wait at least 15 minutes before the camera goes on.
4. Slide the camera on until it clicks, then remove the lens film.
5. Run the cable along the headliner and down the A-pillar. Azuga mentions a cable guide held with 3M tape.

The extra hex screw and cover step in Azuga's guide is listed for the Plus. We did not see it listed for the Pro, so follow the guide for your model.

Planning around the aux cameras

A Pro with aux cameras has more cable around the mirror area. Plan the route for the aux splitter and the main power cable together before you stick the plate, so that neither gets pinched against it. A plate that is in the wrong place has to be replaced, so this is the moment to think it through.

Where to go next

Questions we get

Can I reuse an old plate on a new windshield?

The plate is stuck to the glass, so a new windshield needs a new plate. At $10 that is a small cost.

What if the road view and driver view cannot both be right?

Azuga says the road view has priority. Move the plate position if you must, and check both again with live streaming.

Is it the same part as the Plus mount?

The shop lists them separately at the same price. Azuga does not say they are interchangeable.

Sources: Azuga shop product page, checked 2026-10-21, Azuga OEM and hardwire install guide, Azuga dash cam page, Azuga OBD-II install guide for the Plus and Pro. AZUGA is a trademark of its owner. API Signal is an independent installer and is not Azuga.