Independent installer of every major GPS, telematics & dash cam brand, including Azuga Call or text: 803-513-1009  ·  info@apisignalcorp.com
Azuga Mastering Azuga ★ Fleet GPS Trackers · Azuga Guide

Azuga Rechargeable Asset Tracker GV620MG, the hardwired tracker with a backup battery

Azuga's hardwired asset tracker for trailers and powered equipment. Wiring, battery, mounting and what to watch for.

5800 mAh
Backup battery
120 days
Standby, per Azuga
IP67
Ingress rating
18-pin
Harness
← All Azuga products Technical information, lights and wiring →

What it is

The Rechargeable Asset Tracker GV620MG is the hardwired member of Azuga's asset line. It connects to the power on a trailer, tanker, reefer or flatbed, and keeps a 5800 mAh battery as backup. Azuga says that battery can hold it for up to 120 days of standby.

Azuga's help center has an install guide for it that is marked last verified September 2025.

Rechargeable Asset Tracker GV620MGbracket mount, antenna side upCELGPSPOWER
Our drawing of a hardwired asset tracker with its three lights, CEL, GPS and POWER. Azuga does not publish the light colors, so the colors on the technical page are marked unconfirmed.

What it does that the battery-only trackers do not

  • Reports more often on power. With external power it can report on a faster schedule than a battery-only tracker. For the older GV600, Azuga gave 2 minutes with ignition on and 8 hours with ignition off. Azuga has not stated the GV620MG interval.
  • Engine hours. The white ignition wire lets it see when the asset is running, if you tie it to a circuit that is live only while the asset operates.
  • Temperature. The grey wire is a 1-Wire input for temperature sensors, up to 8 sensors per Azuga.
  • Equipment beacons. It detects Azuga Equipment Beacons on tools and small equipment.

The published specs

ItemValue
Size and weight138 x 66 x 38 mm, 320 g (11.29 oz)
RatingsIP67, -30 to +80 C
Power8 to 32 V external, one external source supported
Battery5800 mAh, two 18650 Li-ion cells, 3.7 V. Charging temperature +10 to +45 C.
StandbyUp to 120 days
Interfaces1 ignition input, 1 analog input 0 to 32 V, 1-Wire up to 8 sensors, 3.3 V output, 4 configurable digital in or out, 1 RS232

Mounting, in Azuga’s order

Face the antenna side up with a clear view of the sky, on a stable surface, with the lights visible. Do not mount it under metal or in an enclosed space. Fasten the front screws first, then the four bottom-shelf screws in a crisscross pattern. Do not fully tighten any screw until all four are in. Then tighten evenly so the seal stays waterproof.

Where Azuga contradicts itself

The guide asks for the serial number in step 1 but searches by IMEI in step 3. The pin table says 8 to 32 V while the wiring step says +12 or +24 V. Neither changes the install, but note both on the job sheet.

A strong fit

Trailers, tankers, reefers and flatbeds where the asset has power and you want engine hours or temperature, with a battery that rides through a disconnect.

Plan ahead

A tracker that must report fast with no power at all, or an install where you cannot reach a constant and a switched circuit that suit the asset.

Questions fleets ask

Which wires do I connect on the GV620MG?

Azuga's guides name four: red for constant power from 8 to 32 V, black for ground, white for ignition detect, and grey for a 1-Wire temperature sensor. The older GV600 article says Azuga supports only red and black. Connect red and black for tracking, and add white only if you want engine hours.

How long does the internal battery last?

Azuga says up to 120 days of standby. In that mode it reports one location and stays online for 15 minutes a day. The battery is 5800 mAh, built from two 18650 Li-ion cells.

What do the CEL, GPS and POWER lights mean?

Azuga documents four patterns: slow flashing CEL means registered on the cellular network, GPS on means it has GPS information, fast flashing POWER means external power is in and the battery is charging, and POWER on means external power is in and the battery is full. See the technical page.

Can it read Azuga equipment beacons?

Yes. Azuga says the GV620MG detects Azuga Equipment Beacons. Azuga help says a tracker can pair with 100 or more beacons, while azuga.com says up to 50 nearby at once.

Sources: GV620MG install guide, GV620MG guide, second article, GV620MG technical specifications, Azuga asset management page. AZUGA is a trademark of its owner. API Signal is an independent installer and is not Azuga.

Azuga Installed Right

Tell us how many vehicles and what they are. We'll quote the installation.

Constant. Ignition. Ground. API Signal.

Disclosure: API Signal may receive a referral fee from Azuga when a fleet signs up with Azuga through us. It does not change what we tell you on these pages, including the places where Azuga is not the best fit.