Azuga JBUS 6 Pin Y Cable

At a glance

What it is

This is the 6 pin standard Y cable in the Azuga shop. The shop describes it as an 800 mm cable, about 2.5 feet, made for trucks with 6 pin JBUS ports. Its job is to let two devices connect at the same time without interrupting the data flow. That is all the shop text says, and we are careful not to add to it.

Why a truck needs a Y-cable at all

Heavy trucks usually have one diagnostic port, and that port is often already taken. An electronic logging device, a transmission tool or an older tracker may already be sitting in it. If you simply unplug it, something stops working. A Y-cable gives you one plug into the truck and two sockets on the other end, so the original device stays in service and the new one rides along.

Azuga's own install guide for its logging device describes the same idea on the 16 pin car and light truck port: when that port is occupied, use the Y-cable. The guide does not say whether an occupied 6 pin or 9 pin heavy truck port needs the existing device removed first. We treat that as not verified.

How we would use it on a job

1. Look at the truck first. Find the port and confirm it really is 6 pin before you order anything. A 9 pin port needs a different cable.
2. Check what is already plugged in. Write down what it is and who owns it. Never leave a customer's existing device unplugged by accident.
3. Turn the vehicle off before you connect anything, the same rule Azuga gives for its plug-in tracker.
4. Plug the Y-cable into the truck, then reconnect the original device to one leg and the new Azuga device to the other.
5. Route the cable so it cannot be pulled, pinched or rubbed through. Heavy trucks vibrate hard, and an 800 mm cable has little slack to waste.
6. Start the engine and confirm both devices still report. A Y-cable that works on the bench can still fail on a worn truck connector.

What to check before you buy

• Port type. Count the pins. This cable is for 6 pin ports only.
• Which device goes on the second leg. Azuga does not publish a compatibility list for this cable, so ask Azuga which of its JBus devices it supports.
• Stock. It showed in stock on 2026-10-21, but the shop changes without notice.
• Price. It was $29.99. The plain 6 pin extender cable (C601-0014) was $15, so the extra cost is for the second socket.

Y-cable or extender cable

If nothing else is plugged into the port and you only need to move the connection point to a better spot, the plain extender cable is the simpler part. If another device must stay connected, you need the Y. Pick by what is in the port today, not by price.

Where to go next

Questions we get

Is this the same as the 9 pin Y cable?

No. The shop sells this one for 6 pin ports. The 9 pin cables in the shop are extender cables, listed separately, and we did not see a 9 pin Y cable in the listing we reviewed.

Does it work with every Azuga tracker?

We do not know. The shop text does not list compatible Azuga devices, so we will not claim it. Ask Azuga before you order for a fleet.

Can it replace an extender cable?

It can reach the same place, but it costs about twice as much. Use the Y only when a second device has to stay connected.

Sources: Azuga shop product page, checked 2026-10-21, Azuga JBus install guide, Azuga ELD install guide. AZUGA is a trademark of its owner. API Signal is an independent installer and is not Azuga.