Wiring Database / Chevrolet / Impala / 2019
Full-size sedan. Push-button start.
On a 2019 Chevrolet Impala, take constant power from the Red/Purple wire at the BCM above the driver kick panel, blue 27-pin plug, pin 4, ignition from the Purple wire at the BCM, green 25-pin plug, pin 6, and ground to clean, bare body metal. Meter every wire first.
Written by API Signal, fleet GPS and camera installers for 35+ years across Georgia, South Carolina and North Carolina, installing every major telematics and camera brand. Every wire on this page lists its source.
No wiring information is ever guaranteed. Colors and locations change with trim, options and build date, and the manufacturer can change them in the middle of a model year. We share this as a starting point for installers, and you are responsible for confirming every connection on the truck in front of you.
This page covers the 2019 Chevrolet Impala.
This year is push-button start only. The only wire sheet we found is for a keyed 2015 car, so the colors are carried to 2019. Meter the ignition and accessory pins before you trust them. Our own team has not yet metered these on this car.
We send fleet installation work to independent installers. One job goes to one installer. Now adding network partners in North Carolina.
Take constant, ignition and ground from the same area.
Constant, ignition and accessory are on two plugs of the same module.
Behind the radio. Constant and ground only.
Colors from a 2015 Impala wire sheet on the12volt (Directed data), carried to 2019.
Each chip shows the main insulation color with its stripe. Source: a 2015 Impala wire sheet on the12volt (Directed data).
Source: a 2015 Impala wire sheet on the12volt (Directed data). It is the only wire sheet we found for this body, and it describes a keyed car. Parking brake, seatbelt and a speed wire were not found.
Fuse box locations and fuse numbers from fuse guides for 2014 to 2020. Check the lid label before you use a slot.
Red/Purple at the BCM above the driver kick panel, blue 27-pin plug, pin 4. Always hot, 30A. Meter it before you tap it.
Purple at the BCM, green 25-pin plug, pin 6. Hot in run on a keyed car. Meter it before you tap it.
Green/White (positive +) at the BCM, gray 26-pin plug, pin 2. Hot in reverse. Meter it before you tap it.
Purple/White (positive +) at the BCM above the driver kick panel, black 26-pin plug, pin 11. Hot with the pedal pressed. Meter it before you tap it.
Dark Blue (high) and White (low) at the OBD port, or BCM blue 27-pin plug, pins 24 and 23. High speed GMLAN.
2014, 2015, 2016, 2017, 2018 and 2020. One wire sheet, for a 2015 car.
No one has sent photos for the 2019 Chevrolet Impala yet, so yours could be the first. Every photo, wire color and tip we use goes on this page with your name on it, and it saves the next installer time under the dash.
The plugs, tap points, fuse boxes and ground points. Phone photos are fine.
Tap "Add yours" at the top of this page. Your tip and your photos go in the same box.
We check every tip, then post it here "Compliments of" you, by name.
The installers who helped build this page.
Your name, right on this page, for everyone who uses it to see. Add your tip and your photos in one box.
We install GPS, cameras and telematics across GA, SC & NC — at your yard, on your schedule.